STEPHENS-ADAMSON - carry back

By: Stephens Adamson  09-12-2011
Keywords: belt

Solution: Clean the belt at the discharge point.

Best Solution: Use Stephens-Adamson's engineered belt cleaning system. A in combination with a or an is the most efficient solution for smooth belts. If a single cleaner is required the Pre-Cleaner is recommended for coarse or wet and sticky material and the T-Cleaner and Arm-Cleaner for dry and fine material. For reversible belts a T-Cleaner is a good solution. For cleated belts carrying dry material a Stephens-Adamson or is the best solution. Stephens-Adamson has other belt cleaning solutions as well.

Keywords: belt

Other products and services from Stephens Adamson

09-12-2011

STEPHENS-ADAMSON - new conveying

Reduced belt tensions and optimized idler roll loading mean more tonnage can be handled on the same conveyor without the need to upgrade to larger idlers or a higher strength belt. In the ESIdlerâ„¢ or Super ESIdlerâ„¢ configuration, all four rolls are lower rated and their design capacity is more efficiently utilized. Reducing belt tension, lowering operating costs.


09-12-2011

STEPHENS-ADAMSON - spillage

For maximum wear life and best efficiency, install a on the inside of the bottom of the chute and along the skirt boards to keep material away from the seal. Install a Stephens-Adamson in combination with a Stephens-Adamson Impact Station. The or supports the belt edge, eliminating belt sagging. Deflect the material towards the center of the belt. Solution: Seal the loading area.