Cobble Loc

By: Reliance Supply  09-12-2011
Keywords: sealer

Surfaces must be clean and free of any contaminants before sealing. Concrete should cure a minimum of 28 days before sealing. On smoothly troweled concrete, an acid etch is recommend using muriatic acid.Cobble Loc contains a part A and part B that must be mixed together. On pavers, dilute with one part water to one part mixed sealer and apply with roller or sprayer. Apply a uniform coat heavy enough to wet out joints if sand stabilization is desired. A second coat of sealer may be appropriate depending on the porosity of the substrate. The 2nd coat can be applied after 2 hours of dry time. As a topcoat over Coloron, Colorcrete or TD One Step, apply a uniform coat undiluted by water. To avoid buildup of sealer, do not apply Cobble Loc more than once every 2 years.

READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT

Keywords: sealer

Other products and services from Reliance Supply

09-12-2011

Oxhide

This organic cleaner will remove oxide formed stains (i.e. rust from sprinklers) from bare and coated concrete surfaces. When used on interlocking pavers, the surface will not be etched thus protecting the paver’s colors. Eliminates ugly brown stains formed by rust or fertilizers on concrete surfaces. Apply by spraying or rolling Oxhide on surfaces to be cleaned.


09-12-2011

Cobble Coat

Cobble Coat is a water clear, solvent-based sealer designed to protect and beautify brick pavers, concrete floors, and Texture Deck. Cobble Coat is made from 100% acrylic resins and is higher in solids than most conventional concrete sealers. Cobble Clean and Cobble Prep may be used for specific cleaning situations. Concrete should cure a minimum of 28 days before sealing. Two thin coats provide the best results.


09-12-2011

Cobble Prep

Clean individual stains prior to an entire area efflorescence cleaning only. Always test your surface for color reaction in an inconspicuous area first. Apply the COBBLE PREP solution starting at the lowest point on the surface. Work on 200 – 250 square foot sections at a time. READ LABEL THOROUGHLY BEFORE APPLYING PRODUCT. Make sure the cleaner covers all areas. Repeat operation only if necessary.


09-12-2011

Cobble Clean

Always test sealed surfaces first with COBBLE CLEAN as the strength of the cleaner may strip some coatings.Cut 1 part cleaner to 10 - 15 parts water. Scrub area with a brush or stiff bristle broom.All COBBLE CLEAN applications should be followed with a thorough water rinse. For tough stains and the removal of tiremarks, COBBLE CLEAN may be used straight. It may be necessary to repeat cleaning.