Pacific Power Source : Products : MS Series

By: Pacific Power Source  09-12-2011
Keywords: Front Panel

MS Series Battery Support Systems

The battery support system for a single cabinet UMS installation (62.5kVA, 50kW) consists of 30 sealed, maintenance free, immobilized electrolyte, batteries installed in an open battery rack. The UMS system DC voltage regulator provides for automatic charging of the battery system to maintain the proper float voltage.

A battery disconnect center is located on the end of the battery rack.

Battery support time at full load (50kW) is approximately 15 minutes. The waveform quality at the end of the battery support time meets the requirements of MIL-STD 1399, section 300A, Types I, II and III power forms.

On-Line, No-Risk Battery Test

This feature of the UMS system provides the ability to perform a battery test on command from the front panel or RS-232 serial port. Test results are displayed on the front panel and are available over the serial port as a part of the system diagnostics. A battery failure during the test will not cause the system to drop the load or distort the output waveform.

Keywords: Front Panel

Contact Pacific Power Source

Email - none provided

Print this page

Other products and services from Pacific Power Source

09-12-2011

Pacific Power Source : Products : G Series

Up to 99 different waveforms may be stored in the waveform library for execution as part of a steady state test program or for substitution in any output phase as part of a transient test program. Provides the ability to create and execute on command, transients that occur linearly over a specified time segment to modify output voltage or frequency.


09-12-2011

Pacific Power Source : Products : AMX Series

This technique provides exceptional metering accuracy and resolution, and delivers a high-fidelity waveform back to a host computer for analysis. The UPC controller is essentially a single or three phase AC arbitrary waveform generator and Precision AC metering system. The UPC output metering samples the output volts and amps at 512 samples per measurement using a 12 bit A/D converter.


09-12-2011

Pacific Power Source : Products

For over thirty years Pacific has provided technically advanced, reliable, and cost effective AC Power Solutions to industrial, military and commercial customers. Our products feature fast transient response, tight regulation, high peak current capability and low impedance. Pacific Power Source manufactures high performance AC power conversion products rated from 500VA to 625kVA.


09-12-2011

Pacific Power Source : Products : ASX Series

The UPC Controller is a modular component of the ASX Series and is available in four configurations ranging from 1 Phase to 3 Phase and Manual Control to Programmable Control. ASX Series Power Sources can be equipped with output transformers to provide an alternate output voltage range. Executive voltage is within ±50 mVAC of command voltage referenced to the internal voltmeter with CSC engaged.


09-12-2011

Pacific Power Source : Products : ACX Series

The UPC programmable controller contains waveform libraries which store 22 executable waveforms in Non-Volatile RAM. Expanding the AC Power Source into an Automated Test Sytem. True-RMS metering of volts, amps, and power. PFC input with inrush current limiting.