Pacific Power Source : Products : AMX Series

By: Pacific Power Source  09-12-2011
Keywords: Power Line, Front Panel, slide rails

Output Frequency:

20 to 5000 Hz. Full Power

Line Regulation:

0.1% max for a 10% line change

Load Regulation:

0.25% 20 to 2000 Hz. 0.5% 2000 to 5000 Hz. Can be improved to less than 0.03% with CSC engaged

Output Distortion:

0.1% THD from 20 to 1000 Hz 0.25% THD from 1000 to 5000 Hz



Ripple and Noise:

-72 dB

Response Time:

5µsec. typical to a step load change. Small signal band-width is 5 Hz. to 50 kHz, typical.

All models are designed for operation in 19 inch equipment racks. Models above 1800 VA have side handles for ease of handling.

Mounting:

Standard 19 inch rack. Slide rails are available as an option for all models.

Height:

See model table above for panel height.

Depth:

Will not exceed 24 inches from the front panel to the rear of the chassis, including connectors, handles and cabling.

Cooling:

Forced air, front or side intakes, rear exhaust with auto fan speed control for low acoustic noise operation.

The UPC controller is essentially a single or three phase AC arbitrary waveform generator and Precision AC metering system. The waveform for each phase may be independently selected and may be independently varied in amplitude and phase angle with respect to phase A (3 phase systems).

The UPC output metering samples the output volts and amps at 512 samples per measurement using a 12 bit A/D converter. This technique provides exceptional metering accuracy and resolution (20 bits), and delivers a high-fidelity waveform back to a host computer for analysis.

The UPC includes a remote GPIB interface compatible with IEEE 488.2 and SCPI. An available option is an RS-232 serial port that operates up to 38.4 kBaud.

Frequency:

20.00 to 5000 Hz ±0.01%

Voltage (Direct):

Programmable, 0-VMAX, in 0.1 volt steps (see table).

Phase Angle:

Phase Angle (f) of Phases B and C relative to Phase A is programmable from 0-359° in 1° increments ± 0.5°.

Current Limit:

Current limit is programmable from 0 to I peak maximum of the power source. Accuracy is ± 1%, resolution ± 0.05%.

Waveform Library:

Stores up to 15 waveforms that can be edited and executed in any manner and in any output phase.

Voltmeter:

Range: 0-354 volts L-N, 0-708 volts L-L

Resolution: 0.10VAC to front panel, 0.001VAC to remote interface

Accuracy: ± 0.25% of reading ± 0.1% of range (50-500Hz)

Ammeter:

Range: 300% of system current rating

Resolution: 0.01AAC to front panel, 0.001AAC to remote interface

Accuracy: ± 0.25% of reading ± 0.1% of range (50-500Hz)

Power Meter:

Range: Based on ammeter range

Resolution: 1.0 watts or VA to front panel, 0.001 Watts or VA to remote interface

Accuracy: ± 1% of Full Scale

Power Factor & Crest Factor:

Calculated and displayed to three significant digits.

Keywords: Front Panel, Power Line, Remote Interface, slide rails,

Contact Pacific Power Source

Email - none provided

Print this page

Other products and services from Pacific Power Source

09-12-2011

Pacific Power Source : Products : G Series

Up to 99 different waveforms may be stored in the waveform library for execution as part of a steady state test program or for substitution in any output phase as part of a transient test program. Provides the ability to create and execute on command, transients that occur linearly over a specified time segment to modify output voltage or frequency.


09-12-2011

Pacific Power Source : Products : MS Series

The battery support system for a single cabinet UMS installation consists of 30 sealed, maintenance free, immobilized electrolyte, batteries installed in an open battery rack. The waveform quality at the end of the battery support time meets the requirements of MIL-STD 1399, section 300A, Types I, II and III power forms.


09-12-2011

Pacific Power Source : Products

For over thirty years Pacific has provided technically advanced, reliable, and cost effective AC Power Solutions to industrial, military and commercial customers. Our products feature fast transient response, tight regulation, high peak current capability and low impedance. Pacific Power Source manufactures high performance AC power conversion products rated from 500VA to 625kVA.


09-12-2011

Pacific Power Source : Products : ASX Series

The UPC Controller is a modular component of the ASX Series and is available in four configurations ranging from 1 Phase to 3 Phase and Manual Control to Programmable Control. ASX Series Power Sources can be equipped with output transformers to provide an alternate output voltage range. Executive voltage is within ±50 mVAC of command voltage referenced to the internal voltmeter with CSC engaged.


09-12-2011

Pacific Power Source : Products : ACX Series

The UPC programmable controller contains waveform libraries which store 22 executable waveforms in Non-Volatile RAM. Expanding the AC Power Source into an Automated Test Sytem. True-RMS metering of volts, amps, and power. PFC input with inrush current limiting.