Servo2Go :: Model 25A8 - Analog Input Brush Servo Amplifiers

By: Servo2go  09-12-2011

The 25A Series PWM servo amplifiers are designed to drive brush type DC motors at a high switching frequency. A single red/green LED indicates operating status. All models are fully protected against over-voltage, overcurrent, over-heating and short-circuits across motor, ground and power leads. All models interface with digital controllers or can be used as a stand-alone drive. They require only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes when SW4 (DIP switch) is ON.

Other products and services from Servo2go


Servo2Go :: Dyna-Lite Series - Right Angle Gearhead Products, Low Backlash

It combines the space and configuration advantages of worm gearing with the high efficiency of bevel gearing but at a tremendous cost savings and a drop-in for many right-angle and in-line planetary gear reducers. The result - the new Dyna-Lite Series is able to achieve ratios up to 15:1 in a single stage and up to 150:1 in two stages.


Servo2Go :: Model GM9234S030 - Brush Mini Gearmotor, Economical

Different reduction ratio's and encoder resolutions, custom cables, optional brush materials, EMI/RFI suppression networks, shaft modifications, shaft-mounted pulleys and gears, ball bearings, special windings and electromechanical brakes. Armatures are skewed to minimize magnetic cogging, even at low speeds, and windings are resin impregnated for greater reliability in incremental motion applications.