Coil Heaters, Square coil, Closed Coil, Mini Coil Heaters

By: National Plastic Heater Sensor & Control  09-12-2011
Keywords: Injection Molding, Nozzle Heaters

Coil heaters also known as cable heaters can be formed to a variety of shapes as required by its many applications. Frequently though, coil heaters are configured as small diameter, high performance nozzle heaters that are fully annealed. Coil heaters are used on injection molding machine nozzles and sprue bushings supplying 360º of heat with optional distributed wattage models also available. Coil heaters are also used as cartridge heaters where irregular size bores are found. A straight, round cable heater can snake through a sealing bar in packaging equipment installations.

Keywords: Injection Molding, Nozzle Heaters

Contact National Plastic Heater Sensor & Control


Print this page

Other products and services from National Plastic Heater Sensor & Control


Solid State Relays, SSRs, Crydon Relays

Solid State Relays are used extensively in the Plastics, Packaging, Food Processing and HVAC industries and are an excellent replacement for electromechanical relays. Solid State Relays will last millions of cycles due to the fact that no mechanical devices are included in the load switching circuit. The term "Solid State" means that these relays do not incorporate any moving parts in the load switching circuit.


Thermocouples & RTDs, Termperature Sensors, THERMOCOUPLES

The thermocouples favorable characteristics include good inherent accuracy, suitability over a broad temperature range, relatively fast thermal response, ruggedness, high reliability, low cost and great versatility of application. Thermocouples are the temperature sensor of choice primarily in plastics extrusion, injection molding, thermoforming, blow molding and blown film applications.


NPH's Industrial Process Heaters, Flanged Immersion Heaters

Industrial process heaters usually consist of the following group of heaters: flanged immersion heaters, screw-plug or bushing heaters, over-the-side immersion heaters, circulation heaters, pipe insert heaters, forced air duct heaters, and tubular heating elements. Typically, they are suitable for the heating requirements of water, oil and other liquid solutions as well as air and other gases.


Mica Heater Bands, Metric and Imperial Heaters

Although their maximum sheath temperature is limited to 900 deg F, with different electrical termination styles, clamping mechanisms, and ability to accommodate holes and cutouts, mica insulated band heaters are successfully used in many applications, but are mostly sought for in the plastics industry. Mica insulated band heaters are efficient and economical solutions to the heating requirements of many applications.


Fuzzy Logic Temperature Controllers, Process Controllers, PID Temperature Controls

The advanced Smarter Logic "Fuzzy" allows processes to be controlled better than ever before, with virtually no initial overshoot or temperature variations. An optional dwell timer enables an event to be timed on or off when preset temperature is attained. 1/16 DIN Fuzzy Logic Temperature Controllers can easily be configured to provide precise control. Splash & chemical resistant sealed mylar front panel. Automatic tuning of PID parameters.