Canadian Feed Screws - Services & Capabilities

By: Canadian Feed Screws  09-12-2011
Keywords: Screws, Barrels

Although it is preferred to do parts assessments in our plant as our inspection area is well suited for complete and thorough inspections, a general inspection of your screws and barrels can be performed in your plant. We have our qualified technician come onsite to measure the screw OD, along its entire length and the barrel I.D at key depths - at the typical wear areas.

Parts are also visually inspected, and evident defects are noted eg. chips, broken areas, severe wear etc.

The general conditions of the parts are discussed, then followed-up with our report and a quotation of our recommendations.

There is a modest charge for this service. When your parts are sent to our plant for inspection and assessment, this service is complimentary.

Keywords: Barrels, Screws