Combustion

By: Ensign Ribbon Burners  09-12-2011
Keywords: Gas, blower, Burners


Combustion System
A ll burners require a mixture of fuel and air in order to work properly. This mixture can be supplied by use of an Inspirators, using the gas pressure to induce an air flow, or through a Fueljector, wherein the air pressure induces a gas flow. This second system can be constructed with either an air supply from compressed air and an Inspirators or with a blower. The use of a blower allows the system to operate independent of the availability of shop air. This system can be built for as little as 2 burners, up to 20 or more.
Each burner would be equipped with its own flame safety control, with the gas solenoids prepiped on the system. Air and gas mixture are adjustable independently on each burner. The combustion air blower is provided with an air filter. The electrical panel is wired for either 208/230V or 460V 3Ø. All systems of 100,000 BTU's or more are provided with dual gas safety valves, pressure regulator, zero gas regulator, high and low gas pressure switches, as well as a proof of closure switch for IRI requirements. The entire system is built to allow replacement of parts without dismantling the entire gas train.Click on picture to enlarge. Unit Shown
Dimensions
32" Deep X 32" Wide X 40" Height
Electrical Power
230/460V 3Ø 60Hz
Capacity
240,000 BTU's
Gas Connection
1".

Keywords: blower, Burners, Gas

Contact Ensign Ribbon Burners

Email - none provided

Print this page

Other products and services from Ensign Ribbon Burners

09-12-2011

Accessories

Nickel Plating In applications where Government regulation or environmental condition require non-corrosive components, ERB can provide nickel plating for any of its burners or products.Hoses Ensign can supply a variety of flexible metal hoses for air and gas connection to your burners.


09-12-2011

Dual Flame Band Burner

For applications where carbon dioxide is present in the sample gas, the EES retards passivation of the sensor anode by allowing the products of oxidation to dissolve in the electrolyte. The electronics enclosure used for the portable and panel mounted versions is made from durable polycarbonate and, together with the gasketed seals, is rated watertight NEMA 4X.


09-12-2011

Ignition and Safety

Made of non-corrosive stainless steel bodies, the cartridges are made of the highest grade steatite that can withstand temperatures up to 1,700° F without breaking. ERB Ignition Electrodes are heavy duty, long lasting ignitors that are available in any length and design(straight, bent, flag, Spark N Ground, ect..).