Motor E 50 MK I / MK II Conversion Kit
Correct decoupling of the motor from the chassis is a key element in any turntable design. Poor decoupling produces rumble and speed/pitch variations. This was recognized early on by Thorens, and accounts for the differences in motor decoupling between the TD 124 Mark I and Mark II models. On the Mark II, the motor suspension rods were lengthened and additional damping devices two per suspension point, as against one per point in the Mark I were employed to achieve better decoupling.
The Conversion Kit includes:
- 3 extended motor suspension rods
- 6 rubber motor suspension dampers
- 3 gasket sets for the rubber dampers
- 1 bolt and lock washer
- 1 installation instructions
The conversion requires only basic mechanical proficiency. As one of the three suspension rods is threaded, an electric drill is required.
Item # 3003$190 usd
The information in this article was current at 06 Dec 2011