MH&W: Machining Services and Capabilities

By: Mh&w International  09-12-2011
Keywords: Ferrite Cores

MH&W offers full service gapping and grinding of your ferrite cores.


MH&W provides a diverse array of custom machining services:

  • Precision gapping of ferrite cores
  • Precision inductance testing utilizing Hewlett Packard test equipment
  • Short runs & production quantities
  • Shortest lead-time in the industry
  • Prototype development
  • Excellent packaging of your custom gapped cores

Machining Capabilities

The precision workmanship is of the highest quality, surpassing your most exacting specifications.

  • Cutting
  • Slicing
  • Surface Grinding
  • Polishing
  • Gapping
  • Slotting
  • Planar Core Conversion
  • Height Modification

For more information, please visit our gapping partner,


Keywords: Ferrite Cores

Contact Mh&w International


Print this page

Other products and services from Mh&w International


MH&W: TDG Ferrite Materials

TDG Ferrite Material Selection Guide & Cross Reference. Middle Frequency,Low Loss underBroad Temp. Low Core LossUU Cores for Flybacks.


MH&W: Bobbins and Accessories

Over the past 10 years there are several RMI cores that have become prevalent taking into account the leg length and coil depth to correspond to specific circuit board thickness. Both TDK and Epcos has a broad range of core shapes and sizes including shapes designed specifically for Planar. MH&W has put together several combinations of RMI planar cores that are in common use in the NAFTA areas.


MH&W: Magnetec Nanocrystalline Cores

Nanocrystalline materials have a proven record of high performance, there has been improved reliability in the manufacturing process and this material is now available from multiple sources. Nanocrystalline soft magnetic materials are now superior to permalloys, ferrites and even amorphous cobalt based alloys in a growing range of applications.


MH&W: TDK Ferrite Cores

TDK power core offers a three pack of power; PC47 for the lowest possible losses at 100°C, PC95 for low core losses over a wide temperature range and PC90 for high Bsat for output chokes. TDK corporation has introduced the PC47 Power Material as the next generation power material to replace both PC40 and PC44 power materials. As power supply frequencies continue to increase over the 250KHz region, the usage of PC40 and PC44 has been decreasing.


MH&W: CSC Powder Cores

High Flux and Sendust powder cores are better choice for the power factor correction, switching regulator inductors, in-line noise filters, pulse and flyback transformers, and many other application required for low losses at high frequencies. Powder cores are distributed air gap cores made from ferrous alloy powders for low losses at high frequencies. DC-AC reactor for renewable & alternative energy. Choke Coil for LCD Back Light Inverter.