Model Aviation Products :: ElectroDynamics

By: Model Aviation Products  09-12-2011

ED-Nano (A123) Battery 2S1P with 22AWG Rx connector and JR Node/Balance connector. Suitable for all Receivers, most do not require a regulator (check with your radio manufacturer). For matching switch, check out our Ultra Switch II ED-Nano.

Size: 1.5"W x 2.7"L x .85"D
Wt. : 3.0oz.Approved chargers:
  • CellPro 4s
  • CellPro MultiPro
  • CellPro 10s

Contact Model Aviation Products

Email - none provided

Print this page

Other products and services from Model Aviation Products


Model Aviation Products :: Accessories

Some other mini servo also can be fit to this mount if there are the same size. Hitec 635, 5645, 5945, 5975 and standard Futaba servo.


Model Aviation Products :: 500 Series Retracts

If you prefer wire struts, we carry a brass adapter that can be soldered to the wire and will fit the 500 Series retracts. The air pressure required to effectively operate the retracts is 50-75psi, depending on the strut and wheel weight. The 500 Series Retracts have been discontinued and have been replaced with a new and Superior Version. Angle stock anodized aluminum side frames for added strength.


Model Aviation Products :: Micro Retracts

The minimum air requirement is approximately 70 lbs., depending on the size and the weight of the wheels used. The 'gear down' function is affected because the spring struggles to lower and lock the gear into position. A three gear set, including air tank, air valve, fill valve, tubing and wire struts weighs in at 3 ounces. Initial results indicate that the retracts did work, although they did need to be cycled a second time.