SOC Robotics MC433 Stepper Motor Controller

By: Soc Machines  09-12-2011
Keywords: motor

Software Tools
The MC433 is designed to work with a variety of third party G Code software programs.  Step input for each axis requires an active high pulse lasting at least 2useconds – step inputs are edge triggered.  A high level on the Direction input will turn the stepper clockwise or counterclockwise depending on how the motor is connected to the drive port.  The direction signal is sampled after the step trigger so it must remain stable for at least 10useconds after the step trigger.

Control Processor Reprogramming
The Software in each Motor Control Processor can be user upgraded the next software release using a free desktop programming utility MC433Prog.exe.  MC433Prog.exe can be downloaded from the download tab.

Expansion Options
The MC433 has several expansion options:  Relay Adapters, Joysticks, DRO and USB Communication Controllers. 

Three Relay adapters are available - each controlled by the Auxiliary output lines. A low current DC relay array capable of handling 24VDC at 2A or 120VAC at 0.4A ,  a high current relay array capable of handling  30VDC at 4A or 120VAC at 2A and a hybrid MOSFET controller that can be configured to control three small stepper motors or operate as 12 independent 2A 30V switches.

Keywords: motor

Other products and services from Soc Machines

09-12-2011

SOC Robotics Products

The family includes low cost IP controllers for embedded web server automation to high performance DSP engines optimized for real time image/video processing running uCLinux. SOC Robotics offers a family of high performance Embedded RISC/DSP engines for Image and Video processing optimized for real time vision processing, monitoring and control.


09-12-2011

SOC Robotics IMU6410 Sensor Platform

Overview The IMU6410 is a sophisticated MEMs sensor Inertial Measurement Unit platform with ten Degrees Of Freedom, onboard AVR processor, real time clock, external serial flash and USB interface. The accelerometer has a sensitivity of 4mG over the full 16G range, a bandwidth of 3500Hz 150Hz, non-linearity less than 1% and a cross-axis sensitivity less than 1%.


09-12-2011

SOC Robotics DOF10W Sensor

The accelerometer is oriented with the X+ on the long axis of the PCB toward Port A connector J1, Y+ on the short axis of the PCB toward Port B connector J2 and Z+ pointing up out of the board. The accelerometer has a sensitivity of 4mG over the full 16G range, a bandwidth of 3500Hz 150Hz, non-linearity less than 1% and a cross-axis sensitivity less than 1%.