Forum Oilfield Technologies | Vanoil - bop lift cap

By: Vanoil Equipment  09-12-2011


The BOP lift cap can be used for lifting equipment, pressure testing equipment, or as a night cap.  It comes with a 1/2” NPT bleed port which can be fitted with a needle valve. The BOP lift cap is of integral design, and features an eye hole for lifting.  Vanoil can manufacture BOP lift caps to fit any size and type of female union.


Contact Vanoil Equipment

Email

Print this page

Other products and services from Vanoil Equipment

09-12-2011

Forum Oilfield Technologies | Vanoil - bop envirosafe dismantling

The quad BOP has a four ram configuration to provide positive protection against blowouts and to secure the well in emergencies. The requirement of harness hoses becomes redundant, thereby effectively reducing the number of hoses and connections. BOPs are available in nominal sizes from 4 1/16” to 5 1/8", with working pressure ratings from 5000 PSI to 15000 PSI.


09-12-2011

Forum Oilfield Technologies | Vanoil - side door stripper

Available with a variety of hand union, or customer specified connections. Packing rubbers can be changed out with coiled tubing still in the well. Can be easily redressed for different coiled tubing sizes. Working pressures from 5000 PSI to 15000 PSI. Standard and sour service environments.


09-12-2011

Forum Oilfield Technologies | Vanoil - ss blowout preventor

BOPs are available in nominal sizes from 3 1/16"" to 7 1/16", with working pressure ratings from 5000 PSI to 15000 PSI. The requirement of harness hoses becomes redundant, thereby effectively reducing the number of hoses and connections. The BOP closure design consists of two hydraulic actuator assemblies connected to each of the ram assemblies.


09-12-2011

Forum Oilfield Technologies | Vanoil - pumpIn flowSub

The pump in/ flow tee sub is a short joint of lubricator with customer specified connections on the top and bottom, with a BX-152 flanged side port. Typically a BX 152 by 2” 1502 WECO thread half adapter is made up to the side port. Available with Flanged, Otis, Bowen, or Slimline hand union connections. Working pressures from 3000 PSI to 15000 PSI.