A&T Rolling & Forming Ltd - bending

By: A&t Rolling  09-12-2011

The ability to provide multiple bends in one piece of pipe including large roll radii and smaller roll radii minimize the amount of joints needed.

In the three examples shown here, the process piping follows the contour of a 10 foot diameter tank as well as changing elevations and directions with minimal weld joints or fittings.


Contact A&t Rolling

Email - none provided

Print this page

Other products and services from A&t Rolling

09-12-2011

A&T Rolling & Forming Ltd - rolling

Shown above are views of rolled Angle Iron, HSS Tubing and Steel Channel Iron used as Structural members erected at a jobsite.


09-12-2011

A&T Rolling & Forming Ltd - forming

In our Shearing And Forming Department we have the capacity to Shear and Brake up to 10' long with a maximum thickness of 3/8". We will Shear customers material to sizes specified including Wire Mesh, Expanded Metal and Perforated Sheet. Our typical Shear and Brake work consists of manufacturing Stairpans, Door Jamb Channels Etc.